Key Features - QDI PlatiniX P8/333 Series Manual

Table of Contents

Introduction

Key Features

Form factor

ATX form factor of 305mm x 232mm

Microprocessor

Supports Intel

/2.8/3.06GHz

Supports 400/533MHz host bus speed

System memory

Supports DDR200/266/333 SDRAM

Supports 64/128/256/512Mb technology up to 2GB

Provides two 184-pin DDR SDRAM interfaces

Onboard IDE

Supports Independent timing of up to 4 drives

Supports Ultra ATA 33/66/100, PIO mode

Two fast IDE interfaces supporting four IDE devices including IDE hard disks and CD ROM

drives

Onboard LAN(Available on -L, -AL, -6AL)(optional)

10/100 Mbit/sec Ethernet support (Intel82562 chip)

1000 Mbit/sec Ethernet support (Intel82540 chip)

10/100/1000M LAN interface built-in on board

USB 2.0/1.0

USB 2.0 compliant, operates at 480Mbps, about 40X times faster than USB 1.1 which cur-

rently works at a snails pace of just 12Mbps

Provides 6 USB 2.0/1.0 ports

Onboard I/O

One floppy port supporting up to two 3.5

/2.88M format

Two high speed 16550 compatible COMs with 16 byte send/receive FIFO (COM1 on back panel,

COM2 on header with optional cable)

One parallel port supports SPP/EPP/ECP mode

Supports PS/2 mouse and PS/2 keyboard

Provides one IrDA connector

All I/O ports can be enabled/disabled in the BIOS setup

Pentium 4 (Hyper-Threading) socket 478 processors

Pentium 4 (Willamette) socket 478 processors at 1.8/1.9/2.0GHz

Pentium 4 (Northwood) socket 478 processors at 1.8/2.0/2.2/2.26/2.4/2.53/2.66

or 5.25

floppy drives with 360K/720K/1.2M/1.44M

QDI

Table of Contents