Draper FOUNDATION Installation Manual page 8

Foundation
Section 3 - Determining Horizontal Mounting Location
Section 3.1 - For LED arrays up to 6 panels high - 2 Horizontal Rails
The Foundation Wall Brackets must be securely anchored to the wall. If mounting to drywall/gypsum board wall, all mounting hardware
anchored to a vertical stud. If mounting to a brick or block wall, the brackets must be evenly spaced no more then 32"
in this manual, the bracket spacing is 24" unless specified otherwise.
The example below is for a 6 x 6 Array. Other standard 2 rail array sizes
Bottom Left Corner
1. Mark the location of the
2. From the mark made in step 1, measure up
This is the top mounting hole location of the
3. Use the chart at right to determine the proper value for
From the mark made in step 1, measure up
This is the top mounting hole location of the
The fully assembled Horizontal Rails
Fig. 3.1
TOP RAIL
MOUNTING
HARDWARE
80 / "
5
8
(2047mm)
or
DIM A
from Chart Above
BOTTOM RAIL
MOUNTING
HARDWARE
19 / "
1
4
(490mm)
LOCATION of
BOTTOM LEFT
LED Cabinet
START HERE
LOCATE BOTTOM LEFT of
or
LOCATE BOTTOM LEFT of
for LED Panels
™
viewing area.
of the
19 ¼"
and draw a level horizontal line the width of the LED display.
(490mm)
WALL MOUNTING BRACKET FOR THE BOTTOM HORIZONTAL RAIL
Dim A.
(Dimension A from chart at right)
WALL MOUNTING BRACKET FOR THE TOP HORIZONTAL RAIL
will be hung from them in Section 5.
(see section 4)
Overall Width with Trim: 145" (3685mm)
Image Width: 144" (3660mm)
PLEASE NOTE:
END OF HORIZONTAL RAIL to be
no more than 16" from the
(406mm)
CENTER of the OUTER Wall Brackets
Image Area
Trim
are shown in the table at right.
(4x4 & 5x5)
and draw a level horizontal line the width of the LED display.
6 x 6 Array Shown
mounting dimension specific
NOTE: If installing trim, you must allow 1
page 8 of 32
(by others)
apart. In the drawings showing
(813mm)
(see Mounting Bracket Detail at right)
.
(see Mounting Bracket Detail at right)
Refer to chart above for
to 4x4 and 5x5 Systems
/ " (33mm) of clearance around th
5
16
must be
.