Power Management Setup - AMD Geode LX800 User Manual

IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector read/write. If
your IDE hard drive supports block mode (most new drives do), select Enabled for automatic
detection of the optimal number of block read/writes per sector the drive can support. The
settings are: Enabled, Disabled.
3-8

Power Management Setup

The Power Management Setup allows you to configure your system to most effectively save
energy saving while operating in a manner consistent with your own style of computer use.
ACPI Function
ACPI Suspend Type
Power Management
PM Times
Standby Mode
Suspend Mode
HDD Power Down
MODEM USE IRQ
PME Event Function
Soft-off by PWR-BTTN
Poweron By Alarm
TIME hh:mm:ss Alarm
IRQ Wakeup Events
↑↓ →←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
ACPI Function
This item allows you to Enabled/Disabled the Advanced Configuration and Power Management
(ACPI). The settings are Enabled and Disabled.
Soft-off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off state.
The settings are: Delay 4 Sec, Instant-Off.
Power On by Alarm
During Disabled, the system will ignore any incoming call from the modem. During Enabled,
the system will boot up if there's an incoming call from modem.
Phoenix – AwardBIOS CMOS Setup Utility
Power Management Setup
Enabled
S1(POS)
ACPI
Disabled
Disabled
Disabled
N/A
Enabled
Instant-off
Disabled
0
Press enter
F6:Optimized Defaults
Menu Level >
F7:Standard Defaults
33
Item Help