AMD Geode LX800 User Manual page 33

Disabled (default) No warning message to appear when anything attempts to access the
Enabled
Hard Disk Boot Priority
The selection is for you to choose the hard disk drives priorities to boot from.
Quick Power On Self Test
This category speeds up Power On Self Test (POST) after you power on the computer. If
this is set to Enabled, BIOS will shorten or skip some check items during POST.
Enabled (default)
Disabled
First/Second/Third Boot Device/Boot Other Device
The BIOS attempts to load the operating system from the devices in the sequence selected in
these items. The settings are Removable, Hard Disk, Legacy LAN, CDROM and Disabled.
Boot Up NumLock Status
The default value is On.
On (default)
Off Keypad is arrow keys.
Gate A20 Option
Normal
Fast (default)
Typematic Rate Setting
Keystrokes repeat at a rate determined by the keyboard controller. When enabled, the
typematic rate and typematic delay can be selected. The settings are: Enabled/Disabled.
Typematic Rate (Chars/Sec)
Sets the number of times a second to repeat a keystroke when you hold the key down. The
settings are: 6, 8, 10, 12, 15, 20, 24, and 30.
Typematic Delay (Msec)
boot sector or hard disk partition table.
Activates automatically when the system boots up causing a warning
message to appear when anything attempts to access the boot sector
of hard disk partition table.
Enable quick POST
Normal POST
Keypad is numeric keys.
The A20 signal is controlled by keyboard controller or chipset hardware.
The A20 signal is controlled by chipset specific method.
28