56F805Evm Connections; Connecting The 56F805Evm Cables - Motorola 56F805 Hardware User Manual

Table 1-1. 56F805EVM Default Jumper Options (Continued)
Jumper
Group
JG17 CAN termination unselected
JG18 Use on-board crystal for oscillator input

1.3 56F805EVM Connections

An interconnection diagram is shown in
+12V DC power supply to the 56F805EVM board.
PC-compatible
Computer
Figure 1-3. Connecting the 56F805EVM Cables
Perform the following steps to connect the 56F805EVM cables:
1. Connect the parallel extension cable to the Parallel port of the host computer
2. Connect the other end of the parallel extension cable to P1, shown in
on the 56F805EVM board. This provides the connection which allows the host
computer to control the board.
3. Make sure that the external +12V DC, 4.0A power supply is not plugged into a
120V AC power source
4. Connect the 2.1mm output power plug from the external power supply into P2,
shown in
Figure
5. Apply power to the external power supply. The green Power-On LED, LED10, will
illuminate when power is correctly applied.
1-4
Freescale Semiconductor, Inc.
Comment
Figure 1-3
Parallel Extension
Cable
Connect cable
to Parallel/Printer port
1-3, on the 56F805EVM board
56F805EVM Hardware User's Manual
For More Information On This Product,
Go to: www.freescale.com
for connecting the PC and the external
56F805EVM
P1
P2
External
with 2.1mm,
+12V
receptacle
Power
connector
Jumpers
Connections
NC
1–2
Figure 1-3,
MOTOROLA