Cable Connection - Oce fx2081 User Manual

2.3 Cable connection

NOTE
To connect the machine to an Ethernet network, a LAN cable (twist pair
cable with RJ-45 type modular connector) is required (a LAN cable is not
included with this kit).
1
Turn the machine off.
2
Plug one end of the 10Base-T/100Base-TX LAN cable (category 5) into
the LAN connector on the left side of the machine.
Connect to the Ethernet hub.
3
Plug the other end of the LAN cable into the 10Base-T/100Base-TX Eth-
ernet hub.
4
Turn the machine on.
LINK lamp:
Illuminates when connected to the LAN.
LAN Connector
ACTIVITY lamp:
Blinks when there is data traffic
on the LAN.
LAN cable:
10Base-T/100Base-TX cable
RJ-45 connector
2-3