Honeywell BENDIX KING KMH 880 System Installation Manual page 194

B
2 and 10 nautical mile range rings.
Set TAS RANGE switch to 15 nautical miles. The following
properly scaled range rings should be visible:
2 and 15 nautical mile range rings.
Set TAS RANGE switch to 20 nautical miles. The following
properly scaled range rings should be visible:
5, 10, and 20 nautical mile range rings.
Set TAS RANGE switch to 40 nautical miles. The following
properly scaled range rings should be visible:
On the traffic display unit, an outer ring represents maximum nautical (nm) dis-
play scaling as selected on the RANGE switch.
If applicable, test the FL (Flight Level) function as follows:
Press the FL switch.
Observe that the traffic display indicates "FL" in the upper left hand
corner. It will be FL --- (flagged) on most displays unless encoding
altitude source is higher than 18,000 feet.
Pass/Fail _____
If applicable (-0901 and -1001 versions of the CP 66B with a
Honeywell Multi-Functional Display), check that the display modes
can be selected properly via the MAN_AUTO discrete as follows:
Via the separate Man/Auto switch, ground MAN_ AUTO,
CP 66B J1 pin 23, and verify that when TCAS is not selected
on the Multi-Functional Display, it only displays TAS information when
a TA is in effect.
Via the separate Man/Auto switch, open MAN_AUTO, CP 66B
J1 pin 23, and verify that TAS information is displayed on the
Multi-Functional Display only when TAS has been selected on it
regardless of whether there is a TA in effect.
Page 4-24
NOTE
10609I00.ZIPCDL
KMH 880/KTA 870
______
______
______
Rev 0, October/2000