Broadcom NetXreme-C User Manual page 36

NetXtreme-E User's Manual
0x001A
0x001B
0x001C
0x0020
0x0021
0x0022
0x0023
0x0024
0x0025
0x0026
0x0027
0x0028
February 26, 2018 • NetXtreme-E-UG100
Windows Driver Advanced Properties and Event Log Messages
Table 23: Event Log Messages (Cont.)
Incompatible speed selection between Port 1 and Port
2. Reported link speeds are correct and might not
match Speed and Duplex setting.
Incompatible speed selection between Port 1 and Port
2. Link configuration became illegal.
Network controller configured for 25Gb full-duplex link.
RDMA support initialization failed.
Device's RDMA firmware is incompatible with this
driver.
Doorbell BAR size is too small for RDMA.
RDMA restart upon device reset failed.
RDMA restart upon system power up failed
RDMA startup failed. Not enough resources.
RDMA not enabled in firmware.
Start failed, a MAC address is not set.
Transmit stall detected. TX flow control will be disabled
from now on.
Page 36