Sil Configuration Warning; Backlight - AUMA SA3 Manual

Information
6.2 SIL configuration warning
6.3

Backlight

Not ready REMOTE (S0006)
Indication S0006 shows the number of occurring messages which are part of the Not ready
REMOTE group.
If a safety function is active (
function active Not ready REMOTE group. Refer to
Figure 11: Signal: Safety function active
As soon as a safety function is active (SIL function active indication), the actuator is controlled
via the safety PLC and the SIL module. For "standard control" (standard PLC), controls are
therefore "Not ready REMOTE".
In combination with the safety functions, the following configurations or settings of standard
controls may have an impact on the standard functions:
• Non-Inching Local=OPENCLOSE
• Non-Inching Remote=OPENCLOSE
If one of these configurations is selected in the standard controls, it does not mean that the
safety function will work in the Non-Inching manner and the Safety function will be active as
long as the signal is present.
In standard operation, display backlight of actuator controls is white. In the event of a fault, the
display backlight is red. The red backlight does NOT refer to the safety function status but to
the faults referred to as "fault" in the manual (Operation and setting) 3.XX /NI.
Safe ESD or Safe STOP ), the indication is listed in the
Details > Status
21
Multi-turn actuators
SA series with Control 3.XX /NI/SIL
for further details.
SIL