Chapter 3 Mechanical Installation; Unpacking; Environmental Conditions; Mounting To A Work Surface - THORLABS MFF101 User Manual

Chapter 3 Mechanical Installation

3.1 Unpacking

Retain the packing in which the unit was shipped, for use in future
Once removed from its packaging, the filter flipper is easily damaged by
mishandling. The unit should only be handled by its base.

3.2 Environmental Conditions

Operation outside the following environmental limits may adversely
Location
Maximum altitude
Temperature range
Maximum Humidity
To ensure reliable operation the unit should not be exposed to corrosive agents or
excessive moisture, heat or dust.
If the unit has been stored at a low temperature or in an environment of high humidity,
it must be allowed to reach ambient conditions before being powered up.
The unit must not be used in an explosive environment.

3.3 Mounting to a Work Surface

The safety of any system incorporating this equipment is the
responsibility of the person performing the installation.
3.3.1 General
When mounting the flipper close to other equipment, ensure that the travel is not
obstructed. If a device mounted on the flipper is driven against a solid object, damage
to the internal mechanism and the optic fitted could occur. The range of travel is 90°
8
Note
transportation.
Caution
Warning
affect operator safety.
Indoor use only
2000 m
o o
5 C to 40 C
Less than 80% RH (non-condensing) at 31°C
Warning