Installer Mode; Dip Switches Parameters - Salus RT510 Full User Manual

7. Installer mode

To enter installer parameters please follow steps below. Please refer to parameters table description before any changes. Use
up or down between all parameters. Every change/selection confirm by
1
3 sec
simultanously for about 3 seconds to
DETAILED TABLE WITH ALL INSTALLER PARAMETERS:
dxx
d01 Temperature display accuracy
d02 Temperature offset
d03 Frost Protection setpoint temperature
d04 Schedule type

7.1 DIP switches parameters

DIP switched are used to set chosen control algorithm. They are under back cover of the thermostat (please refer to the picture below):
Type of control TPI
When TPI is selected on DIP switch № 2, then
DIP switch № 1 is functional. You can choose
How it works the Cycles Per Hour between a lower
comfort level (6CPH) and a higher comfort
level (9CPH).
18
3 sec
TEST / PAIRING
SELECT SET
3 sec
Press and hold + +
enter the installer mode.
Function
button.
2
Use SELECT button to choose parame-
ter, confirm selection by SET button.
To change parameter value use
TEST / PAIRING
SELECT SET
or
by SET button. To exit the installer
mode, wait 10 seconds - thermostat
will re-turn automatically to the main
0.1°C or 0.5°C
+/- 3.0°C
5.0°C - 17.0°C
5/2 or 24 hr (7d)
Hysteresis
When Span is selected on DIP switch № 2, then
DIP switch № 1 is not functional. The SPAN
value is set to ± 0.25°C.
or
TEST / PAIRING
SELECT SET
buttons and confirm selection
screen.
Parameter
0.5°C
0.0°C
5.0°C
5/2 d
buttons to move
Default
value
ON
Span
9CPH ±0.25°C
6CPH TPI
1 2