Administering Several Ecosdetectors; Utilising Feedback Information; Triggering Routes - Esu L.Net converter Instruction Manual

Table of Contents

Advertisement

Utilising feedback information

back module). The feedback addresses 1 – 16 will be displayed on
the first virtual ECoSDetector, the feedback addresses 17 – 32 on
the second one, and so forth.

6.5.2. Administering several ECoSDetectors

When you layout is expanding and you wish to operate several
L.Net converters in mixed mode with ESU ECoSDetectors it may
become necessary to change the sequence of the reference num-
ber at a later stage.
• Simply press the tab "Admin" in the configuration menu. A win-
dow similar to Fig. 10 will open.
Figure 10: Administering several ECoSDetector devices
In this list all detected ECoSDetector modules and L.Net converters
will be displayed with their name and their reference number. The
list is sorted by the reference number.
If you now wish to assign a new reference number to an ECoSDe-
tector respectively an L.Net converter you simply mark the respec-
tive module and press the button "N+" in order to increase the
number or the button "N-" in order to decrease the number.
6. Utilising feedback information
You may use feedback information supplied by the L.Net converter
in the same manner as is described in the ECoS handbook, chapter
15. Of course, now there are not only s88 modules available but
you may also select ECoSDetectors and virtual ECoSDetectors (say:
L.Net converters).

6.1. Triggering routes

If you wish to trigger a route you can now also select feedback
modules from the list, which are connected to the L.Net conver-
ters. This list is sorted by increasing reference numbers.
Figure 11: Routes - select module
Fig. 11 shows two virtual feedback modules ("L.Net Detector [1]"
and "L.Net Detector [2]") besides the "real" ECoSDetectors. The
number in the squared bracket corresponds with the virtual feed-
back modules (in this example for instance the LocoNet™ feed-
back module 1- 16 as well as 17 – 32). Always bear in mind that
you may select in "Port" any number from 1 – 16 in the choice list.
Port number 1 of the "L.Net Detector [2]" therefore corresponds
with the LocoNet™ feedback number 17.
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

50097

Table of Contents