Table of Contents
Advertisement
Nuclias Connect Hub Plus User Manual
Console Connection
Use a console cable to connect to the DNH-200's console port. The console cable should be a
RS-232 serial-to-RJ-45 cable designed to use with the device. A terminal emulation program
is required for serial communication.
1.
Connect the RS-232 interface to the serial port of the management PC.
2.
Connect the RJ-45 interface to the console port of the device.
3.
Open a terminal emulation program on the management PC and configure the
properties for connection as follows:
• The speed (baud): 115200 bps
• The data bits: 8
• The parity: None
• The stop bits: 1
• The flow control should be None.
Start the communication and the Limited Command Line Interface (CLI) should be available.
11
Hardware Installation
Advertisement
Table of Contents
