Table of Contents
Advertisement
Nuclias Connect Hub Plus User Manual
Link Integrity
Ethernet to
WLAN Access
Once the settings are updated, the configuration must be uploaded to the access points. See
Profile Settings for more information.
Wireless Resource
The Wireless Resource function provides real-time RF management of the wireless network.
Navigate to Configuration > Profile Settings > [Site] > [Network] > Wireless Resource.
ACL RSSI Threshold
Aging Out
RSSI Threshold
Data Rate
Connection Limit
Go to this tab. Click the drop-down menu to enable or disable
wireless link integrity. Enable this to disable the wireless network if
the AP is not connected with an uplink router.
Enable or disable Ethernet to WLAN access. If disabled, packets from
the Ethernet port(s) could not be forwarded to the Wireless network.
Check the box to enable ACL Received Signal Strength Indicator
(RSSI) threshold function and click the menu to select the ACL
RSSI threshold percentage.
Select criteria to disconnect wireless clients. Available options
are RSSI and Data Rate.
When RSSI is selected for Aging out, select a value between
10% and 100%. This parameter sets the minimum RSSI for
wireless clients to respond to a probe. If the RSSI of a wireless
client is lower than the specified percentage, the wireless client
is disconnected.
Select the data rate in Mbps for connection limit. The option is
only available when the Aging Out policy is set to Data Rate.
When the data rate of wireless clients is lower than the
specified number, the Hub disconnects the wireless clients.
Enable or disable the limit on wireless connectivity based on the
72
AP Network
Advertisement
Table of Contents
