ADTRAN NetVanta 1224 Installation And Maintenance Practice page 129

Table 5-50. Auto Upgrade Configuration (AUC) Status Menu Options
Option Description
1 AUC Config File
2 AUC Mode
3 AUC Refresh Interval
4 AUC Upgrade Retries
5 AUC TFTP Server
Auto Upgrade operations will not be initiated if the AUC Refresh
Interval option is set to zero, the AUC Config File option is empty,
the configuration file cannot be retrieved from the AUC TFTP
Server, or the configuration file contains errors.
61179621L1-5C
Function
This option is used to enter the AUC Config File name.
The text entry field is limited to 40 characters and must
end with the *.auc file extension.
This option is used to specify the auto upgrade mode.
Options include the following:
• Auto - indicates that unit should be automatically
checked and upgraded.
• Manual - indicates that unit should be checked at
the AUC Refresh Interval rate and upgraded only
when instructed via SNMP or the menus.
• Disable - all automatic upgrade operations are
disabled.
This option specifies how often (in hours) the unit
should check the AUC TFTP Server for changes to the
AUC Config File. Valid entries are 0 - 744. A value of zero
(0) indicates the server should not be checked and dis-
ables any further Auto Upgrade operations.
This option specifies the number of software upgrade
attempts that are to be made as a result of a failure.
Valid entries are 0 - 10.
This option specifies the IP address of the AUC TFTP
Server.
NOTE
Menu Descriptions
5-79