Dehumidifying Z - Mitsubishi Electric MJ-EV230HR-H Instruction Manual

Compact and powerful inverter technology, energy saving air purifying function with pm2.5 filter
Table of Contents

Advertisement

Dehumidifying
The operation mode can be selected accordingly to the situation.
1
Press
2
Select the operation mode.
z To select the dehumidifying mode and operate
Press
z To set the humidity and operate
Press
3
Press
<To stop operation>
Press
z The dehumidifier remembers the operation mode. Even if the power plug is disconnected or the power is turned off, the
unit restarts at the previous setting.
z The humidity cannot be set in modes other than "ECO AUTO".
z Operation stops when the tank is full. To restart operation, remove water from the tank. If a continuous drainage hose is set,
the dehumidifier will operate continuously.
z In the case of a power outage during operation, the dehumidifier will restart operation upon restoration in the operation
mode before the power outage.
z If the DRYING INSIDE (auto) operation has been activated, the DRYING INSIDE operation will start after the unit stops.
P18
When drying your shoes, put them in a position slightly higher from the floor so that the air from the dehumidifier is directed to
them.
12
3
2
Blip
to begin operation.
z POWER lamp lights.
z The operation mode is displayed.
z Inverter indicator lights.
z Louvre opens, and blows air.
z The operation mode switches each time the button is pressed.
P13–14
Blip
z The set humidity changes each time the button is pressed.
P13
Blip
Blip
70
65
and select the swing direction.
Blip
z POWER lamp goes out.
z The operation mode indicator goes out.
z Inverter indicator goes out.
P20
2
1
Blip
Blip
Blip Blip
Blip
Blip
60
55
50%
P16
Blip Blip
Blip

Advertisement

Table of Contents
loading

Table of Contents