Table of Contents
Advertisement
Before Using Your Dehumidifier
Setting the PM2.5 filter
The PM2.5 filter is supplied with the unit at time of
purchase. Please install it before using the unit.
1
Remove the PM2.5 filter from the
polyethylene bag.
2
Remove the pre-filter.
Performance is unaffected even if the metal fin
inside the unit are slightly bent.
3
Set the PM2.5 filter.
With the strips facing
up, set the filter inside
the tabs on the pre-
filter.
4
Set the pre-filter.
z Make sure the PM2.5 filter is attached on the unit.
If it is not, fine dust will enter inside the unit and cause
a malfunction.
Carrying the Unit
Hold the handle and move it.
Handle
Pull the pre-filter toward
you, and then remove it.
Strips
Tabs (6)
Insert the bottom tabs
into the unit until they
click.
Casters can be used to move the unit.
First make sure to remove water from the water tank
and close the louvre before carrying the unit.
z If casters are unable to roll smoothly, do not use
z Do not carry the unit by holding the louvre.
z Do not put the unit in horizontal position during carrying as this may
z Use casters to move the unit steadily in one direction.
z Lift the unit up to go over the doorsill or stairs and do not use casters to
z Do not allow the power cord to be pulled into the casters, as this may
Inserting the water
tank correctly
Plugging the power cord
into the power socket
Use a 220V AC power socket only.
˜ The current humidity is indicated.
If the louvre is open, it closes automatically.
excessive force to move this unit so as to prevent
overturning.
cause malfunctions.
move the unit over the shaggy carpet as this may damage the carpet.
damage the cord.
Tank lid
Tank guard
Make sure the
tank guard
is securely
attached.
Blip
9
Advertisement
Table of Contents
