Cutting Wheels - Stihl TS 410 Instruction Manual

English
Shaping pipe
N Mark a cutting line
Manual cutting along this line
requires particular caution and
precision.
N Grind a guide groove along the
marked cutting line – do this by
starting at the apex and cut outward
on both sides
N Cut into pipes, round bodies, etc. in
the area at the ends of the cutting
line, so that the material does not
break away
N Make cuts deeper with even back
and forth motions – start at the apex
and cut outwards on both sides –
feed with full cutting depth along the
guide groove – for small corrections
of direction, do not tilt the cutting
wheel, but always position it anew
instead – if necessary, leave small
12
ridges that hold the part that is to be
separated in position. Break these
ridges later

Cutting wheels

Cutting wheels are exposed to
extremely high loads especially during
freehand cutting.
The cutting wheels, which have been
developed by STIHL in cooperation with
renowned manufacturers of abrasive
wheels, are of high quality and tailored
precisely to the respective intended use
as well as the engine performance of the
cut-off machine.
They are of consistently outstanding
quality.
Transport and storage
– Do not expose cutting wheels to
direct sunshine or other thermal
stresses during transport and
storage
– Avoid jolting and impacts
– Stack cutting wheels flat on a level
surface in the original packaging in
a dry place where the temperature
is as constant as possible
– Do not store cutting wheels in the
vicinity of aggressive fluids
– Store cutting wheels in a frost-free
place
TS 410, TS 420