Stihl TS 410 Instruction Manual page 21

1
4 5
N Turn the guard so that it is in the
position shown (see picture)
N Screw in and tighten the stop pin (1)
N Move the adjusting lever (2) to
position A
N Screw in the bolt (3) and tighten up
N Unscrew the bolt (4) of the limit
stop (5)
N
Remove the limit stop (5)
6
4 5
N Turn the "cast arm with guard" so
that the guard is on the outboard
side
N Insert limit stop (5) – align the hole
in the limit stop with the hole in the
cast arm
N
Screw in the bolt (4) and tighten up
TS 410, TS 420
N Insert the square nut into the guide
in the guard and hold it in place
N Screw in the shorter banjo bolt (6)
and washer at the adjusting lever
A
and tighten up with the combination
wrench
Mount "cast arm with guard" – guard
3 2
on the outboard side
1
2
4
N
Press the oblong holes (1) in the
"cast arm with guard" on to the
studs (2), guiding the ribbed V-belt
over the front pulley
The belt action must run smoothly.
N The belt tensioner (3) must sit close
to the lug (4)
1
2
1
2
3
2
2
2
6
5
6
6
N Fit the "starter cover with rewind
starter" (5) over the studs (2)
N Tighten up the nuts (6) by hand
7
8
N Push the V-belt guard (7) into place
N Screw in the bolt (8) and tighten up
Connect water connection
3
1
2
1
N Insert the longer banjo bolt (1)
through the connector (2) of the
water attachment – observe the
position of the connector
N Insert the square nut into the guide
in the guard and hold it in place
English
19