Stihl TS 410 Instruction Manual page 6

English
Transporting the machine
Always stop the engine.
Carry the machine only by the top
handle – cutting wheel towards the rear
– with the hot muffler facing away from
the body.
Avoid touching hot parts of the machine,
especially the surface of the muffler –
risk of burns!
Never transport the machine with the
cutting wheel fitted - it may break!
In vehicles: Properly secure your
machine to prevent turnover, damage
and fuel spillage.
Refueling
Gasoline is an
extremely flammable
fuel – keep clear of
naked flames and fire –
do not spill any fuel – no
smoking.
Switch off the engine before refueling.
Never refuel the machine while the
engine is still hot – the fuel may spill over
– risk of fire!
Open the fuel filler cap carefully so that
any excess pressure is relieved
gradually and fuel does not splash out.
The machine may only be refueled in a
well ventilated place. Clean the machine
immediately if fuel is spilled. Change
your clothes immediately if they are
contaminated with fuel.
4
Dust may collect on the engine unit,
particularly around the carburetor. If the
dust is soaked with gasoline, it may
catch fire. For this reason, ensure that
the dust is always removed.
Check for fuel leakage
while refueling and during
operation. Never start the
engine if fuel has been
spilled or is leaking –
Fatal burns may result!
Various cut-off machines may be
equipped with various filler caps:
Bayonet filler cap
Never use a tool to open or close the
bayonet filler cap. This could damage
the cap and cause fuel to leak out.
Secure the bayonet filler cap tightly after
refueling.
Threaded filler cap
Close the threaded filler
cap as tightly as possible
after refueling.
This helps reduce the risk of unit
vibrations causing an incorrectly
tightened filler cap to loosen or come off
and spill quantities of fuel.
Cut-off machine, spindle bearing
A faultless spindle bearing ensures the
radial and axial runout of the diamond
cutting wheel – have this checked by a
dealer if necessary.
Cutting wheels
Selecting cutting wheels
Cutting wheels must be approved for
freehand cutting. Do not use any other
cutting wheels or attachments - risk of
accidents!
Cutting wheels are suitable for varying
materials: Observe the cutting wheel
codes.
STIHL generally recommends wet
cutting.
Observe the outer diame-
ter of the cutting wheel.
The diameter of the spin-
dle hole of the cutting
wheel and the shaft of the
cut-off machine must
match.
Check spindle hole for damage. Do not
use cutting wheels with a damaged
spindle hole – Risk of accident!
TS 410, TS 420