Stihl TS 410 Instruction Manual page 10

English
– Always be aware that the object to
be cut may move and other factors
may cause the cut to close and jam
the cutting wheel.
– The object to be cut must be
secured and supported so that the
cut remains open during and after
cutting
– Work with water and wet cutting
when using diamond cutting wheels
– Depending on version, composite
resin cutting wheels are suitable for
dry cutting or wet cutting only.
Always use wet cutting with
composite resin cutting wheels that
are suitable only for wet cutting
Pulling away
The machine pulls forward, away from
the user, when the cutting wheel
touches the object to be cut from above.
8
Working with the cut-off machine
The cutting wheel must
be guided straight in the
cut, without wedging.
Never exert lateral pres-
sure on the cutting wheel.
Do not use the cutting
wheel for lateral grinding
or scrubbing.
Do not stand in line with the cutting
wheel.
Do not lean too far forwards and never
bend over the cutting wheel, especially
when the deflector has been pulled
back.
Don't cut above shoulder height.
The cut-off machine may only be used
for cutting. It must not be used as a lever
or shovel.
Do not press down on the cut-off
machine.
Always decide the cutting direction
before positioning the cutting wheel.
After that, do not change the cutting
direction. Avoid knocks and bumps with
the machine while in the cut – do not
drop the machine into the cut – danger
of breakage!
Diamond cutting wheels: If cutting
performance begins to deteriorate,
check the sharpness of the diamond
cutting wheel, resharpen as needed. To
do this, briefly cut through abrasive
material, e. g., sandstone, aerated
concrete or asphalt.
At the end of the cut, the cut-off machine
is no longer supported by the cutting
wheel in the cut. The machine's weight
must be borne by the user, otherwise
you may lose control of the machine!
When cutting steel: glow-
ing metal particles may
cause fires!
Keep water and sludge away from
electric cables - risk of electric shocks!
To obtain a clean cut: the cutting wheel
should be pulled into the workpiece if
possible or moved back and forth in
cutting direction. It must never be
pushed.
Work with water and wet cutting when
using diamond cutting wheels – e. g.,
use STIHL water attachment.
Depending on version, composite resin
cutting wheels are suitable for dry
cutting or wet cutting only.
Work with water and wet cutting when
using composite resin cutting wheels
that are suitable only for wet cutting –
e. g., use STIHL water attachment.
Use dry cutting when using composite
resin cutting wheels that are suitable
only for dry cutting. If composite resin
TS 410, TS 420