Stihl TS 410 Instruction Manual page 22

English
N Fit the support with the longer banjo
bolt on the adjusting lever (3) –
screw in the banjo bolt and tighten
with the combination wrench
N
Insert the water hose into the guide
in the V-belt guard (arrow) from the
shut-off cock towards the guard –
avoid tight radiuses
Checking the adjustment range of the
guard
N Rotate the guard forwards and
backwards as far as possible –
adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter
"Tensioning the V-belt".
20
Inboard mounting
N
Disassemble the cutting wheel (see
"Fitting / replacing an cutting wheel")
N
Remove water attachment
N Remove the adjusting lever
N Slacken the V-belt
N Remove the V-belt guard
N Remove the "cast arm with guard"
Preparing the "cast arm with guard"
for inboard mounting
A
1 2
N Unscrew the screw (1) of the limit
stop (2)
N Remove the limit stop (2)
1 2
N Turn the "cast arm with guard" so
that the guard is on the inboard side
N Insert limit stop (2) – align the hole
in the limit stop with the hole in the
cast arm
N
N
N
N
N
N
N
N
3
Screw in the bolt (1) and tighten up
Unscrew stop pin (3)
3
Turn the guard so that it is in the
position shown (see picture)
Screw in and tighten the stop pin (3)
Install the adjusting lever
Mount "cast arm with guard" – guard
on the inboard side
Install the V-belt guard
Connect water connection
TS 410, TS 420