Fig. 12: Pc1002-A2 Power Amplifiers Connectors; Table 9: Pv1002-A1 230 V Connector; Table 10: Pc1002-A2 Amplifier Connectors - 'Tr1' To 'Tr6 - Siemens Novigo Core Installation, Mounting

4 Mounting/Installation
Mount and install additional power amplifiers
38 | 121
230 V connector
Pin Description
1 AC 230 V N
2 NC
3 AC 230 V L1

Table 9: PV1002-A1 230 V connector

Fig. 12: PC1002-A2 power amplifiers connectors

PC1002-A2 amplifier connectors - 'TR1' to 'TR6'
Pin Description
1 -
2 +
3 100 V
4 70 V
5 50 V
6 C

Table 10: PC1002-A2 amplifier connectors - 'TR1' to 'TR6'

Follow the steps below to mount the power amplifier PV1002-A1 on PC1002-A2:
 Remove the protection foil from the rear of the amplifier before it is mounted.
1. Screw the 2 lower screws of the amplifier onto the selected position of the
amplifier mounting area.
2. Use these 2 screws as a support to the amplifier and put the amplifier into
place.
3. Use the upper 2 screws to fix the amplifier and tight the lower screws.
4. Connect the speaker cable to the designated speaker line plug.
Remark
Blue
No connection
Brown
Remark
Do not use
Do not use
Speaker line 100 V +, white
Do not use
Do not use
Speaker line 100 V -, green
A6V11940317_en--_a