Replacing The Sec Cartridge And Heat Sink Assembly; Figure 8-8. Sec Cartridge And Heat Sink Removal - Dell PowerEdge 4200 Installation And Troubleshooting Manual

SEC cartridge
release latches (2)
heat sink
metal clips (2)
guide bracket assembly

Figure 8-8. SEC Cartridge and Heat Sink Removal

5. Pull out the cartridge release latches until they
snap into place.
Replacing the SEC Cartridge and Heat
Sink Assembly
Use the following procedure to install the replacement
SEC cartridge and heat sink assembly:
1. Remove the terminator card or old SEC cartridge
from the guide bracket assembly.
Follow the instructions in "Removing a Terminator
Card" or "Removing the SEC Cartridge and Heat
Sink Assembly" found earlier in this chapter, as
appropriate.
supports
2.
3.
4.
SEC cartridge
Slide the SEC cartridge into the guide bracket
assembly, with the heat sink toward the top of the
computer, and firmly seat the assembly (see Fig-
ure 8-9).
Considerable force is required to seat the SEC
cartridge.
Slide the metal clips on the heat sink outward
until the clips latch onto the supports (see
Figure 8-9).
Insert the temperature sensor cable into the
TEMP_n connector on the system board below
the guide bracket assembly.
Installing System Board Options
temperature
sensor cable
temperature
sensor
connector
8-9