Table C-1. System-Board Jumper Settings - Dell PowerEdge 4200 Installation And Troubleshooting Manual

Jumper
EISA
VGA
PASSWD
CRDBIOS
RSRVD2
RSRVD1
*
333MHZ
*
300MHZ
*
Only one of these jumpers should have a jumper plug installed.
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviation and acronym list.
jumpered

Table C-1. System-Board Jumper Settings

Setting
(default)
(default)
(default)
unjumpered
Description
The EISA Configuration Utility settings are
retained at system boot.
The EISA Configuration Utility settings are
cleared at next system boot. (If the EISA Configu-
ration Utility becomes corrupted to the point where
the system won't boot, install the jumper plug and
boot the system. Remove the jumper before restor-
ing the EISA configuration information.)
The integrated video controller is enabled.
The integrated video controller is disabled.
The password feature is enabled.
The password feature is disabled.
Reserved (do not change).
Reserved (do not change).
Reserved (do not change).
The microprocessor's internal speed is 333 MHz
(when available).
The microprocessor's internal speed is 300 MHz.
Jumpers and Switches C-3