Replacing The Computer Covers; Removing The Front Bezel; Figure 7-2. Removing The Computer Covers - Dell PowerEdge 4200 Installation And Troubleshooting Manual

Figure 7-2. Removing the Computer Covers

Replacing the Computer Covers

Use the following procedure to replace a computer cover:
1. Check all cable connections, especially those that
might have come loose during your work. Fold
cables out of the way so that they do not catch on
the computer cover.
CAUTION: Make sure that there are no cables
or cable connectors lying on the top diskette
drive in the upper drive cage. Foreign objects
on top of the drive can interfere with drive
operation and permanently damage the drive.
2. Check that no tools or extra parts (including
screws) are left inside the computer.
3. Make sure the keylock is in the unlocked position.
4. Fit the cover over the side rail at the bottom of the
chassis, and slide it closed.
5. Secure the cover with the three screws.
6. Set the keylock to the locked position.
R
emoving the Front Bezel
Use the following procedure to remove the front bezel:
1. Remove the computer covers.
See "Removing the Computer Covers" found earlier
in this chapter.
CAUTION: See "Protecting Against Electrostatic
Discharge" in the safety instructions at the front of
this guide.
2. Release the two tabs on each side of the bezel (see
Figure 7-3).
3. Slide the front bezel straight forward.
Checking Inside the Computer
screws (6)
7-3