Microprocessor Sec Cartridge/Heat Sink Assembly; Figure 4-23. Removing A Terminator Card - Dell PowerEdge 4200 Service Manual

retaining clip
terminator card
guide bracket
assembly

Figure 4-23. Removing a Terminator Card

Microprocessor SEC Cartridge/Heat Sink Assembly

WARNING: The microprocessor SEC cartridge/heat sink assembly can
get extremely hot during system operation. Be sure the assembly has
had sufficient time to cool before you touch it.
WARNING: When handling the microprocessor SEC cartridge/heat
sink assembly, take care to avoid sharp edges on the heat sink.
1. Unplug the temperature sensor cable from the TEMP_n connector on
the system board.
2. Slide the metal clips on the heat sink inward toward each other.
NOTE: Do not remove the clips from the heat sink.
3. Press the microprocessor SEC cartridge release latches toward the car-
tridge, as shown in Figure 4-24, until they snap into position.
locking mechanisms (2)
notch
bar
Removing and Replacing Parts 4-23