Troubleshooting; Rebooting The Unit - Bosch AUTODOME IP starlight 7000i Installation Manual

AUTODOME IP starlight 7000i
14

Troubleshooting

Access our support services at www.boschsecurity.com/xc/en/support/.
Bosch Security and Safety Systems offers support in these areas:
–
–
–
–
–
–
Visit the Bosch Building Technologies Academy website and have access to training courses,
video tutorials and documents:
14.1

Rebooting the unit

Reboot the unit
After a Factory Default or firmware update, reboot the unit if:
–
OR
–
4
–
OR
–
4
If you cannot control the unit after the firmware upgrade, then cycle the power to the unit. If a
power reset does not solve the problem, or if Configuration or video management software
identifies the unit as "Videojet Generic," then contact your Bosch Service Center for an RMA
for the unit.
Bosch Security Systems
Support
Apps & Tools
Building Information Modeling
Warranty
Troubleshooting
Repair & Exchange
Product Security
Bosch Building Technologies Academy
You cannot connect to the unit in the Web browser.
Configuration Manager or BVMS or similar software identifies the unit as "Videojet
Generic".
Reboot the unit using one of the following methods:
In the web browser, type the IP address and then /reset (without any punctuation). Press
the Enter key.
In Configuration Manager, right-click the IP address and click Restart.
Wait two minutes for the process to complete.
www.boschsecurity.com/xc/en/support/training/
Installation Manual
Troubleshooting | en 63
2021-03 | 1.2 |