Bosch AUTODOME IP starlight 7000i Installation Manual page 29

AUTODOME IP starlight 7000i
Fuse Specifications
Volts
24 V
115 V
230 V
Warning!
Fuse replacement by qualified service personnel only. Replace with same type fuse.
!
Fuse Specifications
Volts
24 V
115 V
230 V
The following table lists the Power Supply Box connectors:
No. Connector
Ground
P101 115/230 VAC or
24 VAC Power In
P106 SERIAL
COMMUNICATIONS
P107 24 VAC Power
(Arm Harness)
Table 9.1: Power Supply Box Connections
Notice!
i
Pins for P106 1, 2, 4, and 5 are used for audio input and output for AUTODOME 7000 Series
cameras; however, their labels are still those of previous versions of analog AUTODOME
cameras.
Warning!
For units intended to be installed outdoors: All wiring (power and I/O cabling) connecting to
!
the unit must be routed separately inside different permanently earthed metal conduits (not
supplied).
Bosch Security Systems
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
XF101 Mains XF102 Camera XF103 Heater
T 5.0 A T 2.0 A
T 1.6 A T 2.0 A
T 0.8A T 2.0 A
XF101 Mains XF102 Camera XF103 Heater
T 5.0 A T 2.0 A
T 1.6 A T 2.0 A
T 0.8A T 2.0 A
Pin 1 Pin 2
Grounding Screw
Line NC
CODE- CODE+
(Audio IN-, (Audio IN+)
Audio in
signal
ground)
Camera Camera
24 VAC 24 VAC
Installation Manual
T 3.15 A
T 3.15 A
T 3.15 A
T 3.15 A
T 3.15 A
T 3.15 A
Pin 3 Pin 4
Neutral
Earth GND RXD
(Ground) (Audio OUT+)
(Audio)
Earth Heater
Ground (24 VAC)
Pin 5 Pin 6
TXD Signal
(Audio OUT-; GND
Audio out (Ground)
signal
ground)
Heater
(24 VAC)
2021-03 | 1.2 |
29