Connection In Applications - Bosch AUTODOME IP starlight 7000i Installation Manual

AUTODOME IP starlight 7000i
FCC & ICES Information
(U.S.A. and Canadian Models Only)
This device complies with part 15 of the FCC Rules. Operation is subject to the following
conditions:
–
–
NOTE: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules and ICES-003 of Industry Canada. These
limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and
radiates radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference, in which case the
user will be required to correct the interference at his expense.
Intentional or unintentional modifications, not expressly approved by the party responsible for
compliance, shall not be made. Any such modifications could void the user's authority to
operate the equipment. If necessary, the user should consult the dealer or an experienced
radio/television technician for corrective action.
1.6

Connection in Applications

24 VAC power source: This unit is intended to operate with a limited power source. The unit
is intended to operate at 24 VAC (if High PoE is not available). User supplied wiring must be in
compliance with electrical codes (Class 2 power levels).
High Power-over-Ethernet (High PoE): This unit can by powered via High PoE. To power the
unit this way, use only approved High PoE devices - those offered or recommended by Bosch.
High PoE can be connected at the same time as a 24 VAC power supply. If auxiliary power (24
VAC to camera and to heater) and High PoE are applied simultaneously, the camera will
selects auxiliary input (24 VAC) as the primary power source.
For pendant models used in outdoor applications that require heaters, a High PoE Midspan
(60 W) by Bosch is required to power both the camera and its internal heaters.
For in-ceiling or indoor pendant applications that don't require heater power, standard PoE+
(IEEE 802.3at) midspans or switches can be used to power the camera.
Bosch Security Systems
this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause
undesired operation.
Installation Manual
Safety EN | en 11
2021-03 | 1.2 |