Wire The Pipe Interface Board - Bosch AUTODOME IP starlight 7000i Installation Manual

AUTODOME IP starlight 7000i
6.
7.
Warning!
You must thread the Dome Cap onto the pipe until it is tight. Failure to do so can result in
!
damage or serious injury or death.
10.5

Wire the Pipe Interface Board

This section provides instructions for connecting wires and cables to the Pipe Interface Board,
as illustrated below. Refer to the Connection, page 55 chapter for cable and wiring
recommendations and specifications.
Figure 10.6: Pipe Interface Board Connections
Bosch Security Systems
Apply the supplied thread sealant to the threads on the Pipe.
Make sure all surfaces are clean and dry.
Apply a bead of sealant completely around the leading threads of the male fitting.
Force the adhesive into the threads to thoroughly fill all voids.
Thread the Pipe Cap onto the down pipe and tighten securely to prevent leaks.
BNC
6
5
4
3
2
1
7
6
5
4
AGND
OUT 3
3
OUT 2
OUT 1
2
1
3
2
1
2
1
Installing the Roof Parapet and Pipe Mounts | en
Installation Manual
47
2021-03 | 1.2 |