Bosch AUTODOME IP starlight 7000i Installation Manual page 36

36 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
Attach the Pendant Arm to the Mounting Plate
The bottom hinge pin of the Pendant Arm is provided with a Hinge Pin Stop to hold the hinge
open while attaching the arm to the Mounting Plate.
1.
Figure 9.9: Connect Pendant Arm to Mounting Plate
2.
3.
4.
Route and Connect Wires to a Power Supply Box
The illustration below depicts the power and control cables connected to the Pendant Arm:
Figure 9.10: Pendant Arm Cables
1
2021-03 | 1.2 |
Compress the bottom hinge pin by pushing the pin lever downward and rotating it behind
the Hinge Pin Stop.
Open the top hinge by pushing its pin lever up and holding it.
Note: Both Hinge Pins must be fully compressed to open (unlock) the hinges of the
Pendant Arm and before proceeding to the next step.
While continuing to hold the top hinge pin open, align the top and bottom hinges of the
Pendant Arm to their mating points on the Mounting Plate.
Once you have the hinges aligned, release the top hinge pin to engage its mating hinge on
the Mounting Plate. Then release the bottom hinge pin from the Hinge Pin Stop to lock
the Pendant Arm to the Mounting Plate.
Cable
Grounding Strap (black)
Cable
5 UTP Video/Ethernet (blue)
Installation Manual
AUTODOME IP starlight 7000i
Bosch Security Systems