Bosch AUTODOME IP starlight 7000i Installation Manual page 37

AUTODOME IP starlight 7000i
2
3
4
Notice!
i
Refer to the Connection, page 55 chapter for wire specifications and distances.
1.
2.
3.
Figure 9.11: Mounting Plate - Inside Detail
Ref.
1
2
3
4.
Bosch Security Systems
24 VAC Power (red)
Relay Contacts (yellow)
Coax Video (black)
(Not applicable for AUTODOME
7000 Series cameras)
Route all incoming wires through one of the earth-grounded conduits at the bottom of the
Mounting Plate. For a mast mount, route all wires through the right-angle conduit.
Attach the water-tight plug to the other conduit.
Attach the grounding spade terminal (item 1, below) to one of the spade terminals inside
the Mounting Plate.
Description
Grounding lug with two spade terminals
Earth ground lug with crimp ring terminal
Wire input conduit holes
Connect the incoming 24 VAC power wires to the 5-pin, 24 VAC Power In mating
connector (supplied with the Mounting Plate kit) for the camera and for the Heater.
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
6 Alarm Outputs (white)
7 Alarm Inputs (gray)
8 Serial Communications (green)
Used for Audio Input/Output in
AUTODOME 7000 Series.
Installation Manual
37
2021-03 | 1.2 |