Bosch AUTODOME IP starlight 7000i Installation Manual page 50

50 en | Installing the Roof Parapet and Pipe Mounts
Pin Description
1
2
3
4
For in-ceiling mount only: Low Voltage TTL (3.3V) can also be used.
4
1.
2.
Caution!
Be careful not to strip the threads when tightening the Pipe Interface Board retaining screws.
!
Figure 10.8: Pipe Interface Board to Dome Cap Assembly
1
2
3
2021-03 | 1.2 |
Pin
Alarm Out 1 1
Alarm Out 2 2
Alarm Out 3 3
Alarm Ground 4
5
6
Connect the plugs to their mating connectors P103 and P102 on the Pipe Interface
Board.
To connect supervised alarms and relays, attach the appropriate wires to their terminals
on the P104 connector on the Pipe Interface Board (see above).
Insert the Pipe Interface Board into the down pipe and fasten the three (3) retaining
screws to secure the board to the Dome Cap.
Interface Board
Retaining Screws (3)
Pendant Mounting Screws (2)
Description
Alarm in 3
Alarm in 4
Alarm in 5
Alarm in 6
Alarm in 7
Alarm Ground
Installation Manual
AUTODOME IP starlight 7000i
Pin Description
1 Alarm Out 4 Normally Open
2 Alarm Out 4 COM
3 Alarm Out 4 Normally Closed
4 Earth Ground
5 Analog Alarm 1
6 Analog Alarm 2
7 Ground
Bosch Security Systems