The Dishwashing Results Are Not Satisfactory - Hanseatic HG6085D137609HW User Manual

Problem Possible cause
The dishwasher salt is
The display
clumpy.
(9) is illuminated
although dish-
washer salt has
been added.
The water is There is a kink in the inlet
not running or it hose.
is running only
very slowly.
The water tap is not on
properly.
The water is not The filters are blocked.
running off or
only very slowly.
The outlet hose is kinked,
has been extended or is
hanging too high up/too low.
The dishwasher The door seal is defective.
is not watertight.
The outlet hose or the inlet
hose is defective.
The dishwasher The dishwasher can only be
can be switched operated when the door is
on/off, but not closed.
cannot be
operated.

The dishwashing results are not satisfactory

Problem Possible cause
There are resi- The rinse aid is incorrectly
dues or streaks dosed.
on the dishes.
There is no dishwasher salt.
The dishwasher salt is
clumpy.
Troubleshooting table
Solution
Stir the dishwasher salt using the end of a
spoon or similar.
Arrange the inlet hose properly so that
it is not kinked (see "Connect the inlet
hose" on page EN-32).
Turn the water tap on completely.
Clean the filters (see "Checking and
cleaning the filters" on page EN-27).
Lay out the outlet hose in the proper man-
ner (see page EN-31).
Have the door seal replaced
(see "Service" on page EN-37).
Have the defective hose replaced
(see "Service" on page EN-37).
Close the door.
Solution
Adjust the dispensed dose (see "Chang-
ing the rinse aid dose" on page EN-15).
Add dishwasher salt (see "Adding dish-
washer salt" on page EN-17).
Stir the dishwasher salt using the end of a
spoon or similar.
Page EN-35