Hanseatic HG6085D137609HW User Manual page 47

Freestanding dishwasher
Table of Contents

Advertisement

Available languages

Available languages

Page EN-8
Safety
NOTICE
Possible damage to property!
Improper handling of the appliance
may result in damage to the appliance
itself.
Only use dishwasher salt which is suit-
able for dishwashers.
Only add dishwasher salt immediately
before the next main dishwashing cycle,
as dishwasher salt which has over-
fl owed can damage the seals and
fi lters of the appliance.
Immediately remove any spilt dish-
washer salt with a damp towel,
as otherwise the stainless steel sur-
face can be damaged.
Ensure that the dishwashing deter-
gent and rinse aid are suitable for the
appliance.
Wipe away rinse aid which has over-
fl owed immediately, as otherwise it
can lead to excessive foaming which
can compromise the results delivered
by the dishwasher.
Do not overload the appliance.
Position the upper dish rack at the
highest setting if very tall dishes are
in the lower dish rack, as otherwise the
upper spraying arm will be blocked.
The door seals are sensitive to oil and
grease.
Do not apply grease to the door seals.
Wipe away grease and oil which has
dripped onto the edge of the open
dishwasher door.
The surfaces can be damaged by un-
suitable cleaning agents.
Do not use harsh, aggressive, solvent-
based or abrasive cleaners.
The appliance is designed for a wa-
ter pressure of 0.4 to 10  bar (0.04 to
1.00 MPa).
If the water pressure is higher than
this, install a pressure reducer.
If in doubt, enquire about the wa-
ter pressure with the water supply
company.
Never connect the appliance to the
water tap or the mixing arm of a water
heater (continuous fl ow heater,
pressure-free boiler etc.).
Ensure that the inlet hose is not
kinked and is carefully connected.
Do not cut through the inlet hose.
It contains electrical components.
If the inlet hose is damaged, have it
repaired by a specialist.
Do not use old or previously installed
inlet or outlet hoses. Only use the sup-
plied hoses.
The outlet hose must be of a minimum
diameter of 40 mm so that the water
can be pumped away unhindered.
Do not attach the outlet hose yourself,
have it installed by a specialist plumb-
er. Have the outlet hose checked reg-
ularly for damage or kinks.

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Hg6085d137609hs4982683074363409

Table of Contents