Test Run - Hanseatic HG6085D137635QW User Manual

Page EN-34 Set-up, connection and initial start-up
Adjusting the water hardness
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the dishwasher using the
button.
2. Press and hold the ˄ (2) button for as
long as required until the current water
hardness is shown on the display:
to .
H6
3. Press the ˄ (2) button as often as required
until the desired setting is displayed.
4. Around 5 seconds after you push it for the
last time, the dishwasher will automatically
revert to the normal display.
The hardness level setting is saved.

Test run

It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
(1)
process and in order to ensure that the device
functions perfectly.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
H1
ready to use.
Carry out this test run when the dishwasher is
empty and without any dishwasher detergent.
See chapter„Operation" from page EN-23 for
the procedure.