Kolida K20s User Manual page 80

K20s
2) Install the receiving antenna onto the rover receiver, and screw the receiver into the carbon
fiber pole, then power on the receiver.
3) Set the receiver as rover with internal radio mode. (set on the control panel, or on internal
Web UI or on the software installed on data collector).
§ 6.2.1.4 Rover settings
Using EGStar3.0
1) Run EGStar3.0 program on data collector;
Go to "Config—Device Config—Instrument Config" page to configure the working mode
2)
and datalink for rover receiver.
Tap on "Work mode setting" and then check the box of "Set work mode", then click on
3)
"Next" to continue;
Check the box of "Rover" option and click "OK" and return to Instrument setting page. At
4)
this moment, KOLIDA K20s prompts the correct working mode with voice guide.
UHF receiving antenna
Rover receiver
- 80 -