Advertisement
COUNTER BORE
3/8" FLAT WASHER
3/8" NYLON LOCK NUT
3/8" FLAT WASHER
3/8" X 5" HEX
HEAD BOLT
STEP #1:
WHILE THE TABLE TOP IS UPSIDE-DOWN, FASTEN THE LEGS TO THE UNDER TOP SUPPORTS BEING
SURE THAT THE COUNTER BORES ARE POINTING TOWARD THE CENTER OF THE TABLE AS SHOWN
ABOVE. USE ( 1 ) ONE 3/8" X 5" HEX HEAD BOLT ALONG WITH ( 1 ) ONE 3/8" FLAT WASHER AND
( 1 ) 3/8" NYLON LOCK NUT PER HOLE TO SECURE.
NOTE: DO NOT TIGHTEN BOLTS COMPLETELY. THIS WILL BE DONE IN A LATER STEP.
www.belson.com
Advertisement
