Related Manuals for Belson Outdoors HB96A
Summary of Contents for Belson Outdoors HB96A
- Page 1 111 North River Road North Aurora, IL 60542 Phone: (800) 323-5664 Fax: (630) 897-0573 sales@belson.com Model # HB96A Instructions Sheet MONARQUE BENCH WITH ARMRESTS www.belson.com...
- Page 2 BEFORE ASSEMBLY, PLEASE MAKE SURE ALL COMPONENTS ARE INCLUDED. C - ARM FP - FASTENER PACK ( 2 ) - TWO ARMS ( 1 ) - ONE FASTENER PACK BENCH END ( 4 ) - FOUR BENCH ENDS D - BENCH BOARD W/ ARM HOLE ( 3 ) - BENCH BOARDS W/ ARM HOLES ( 4 ) FOUR BENCH BOARDS www.belson.com...
- Page 3 BEFORE ASSEMBLY, PLEASE MAKE SURE ALL FASTENERS ARE INCLUDED. 6 - 3/8” X 2 1/2” HEX HEAD LAG BOLT 6 - 3/8” FLAT WASHER 56 - #12 X 2” PAN HEAD PHILLIPS SCREW ALSO NEED FOR THIS ASSEMBLY WILL BE THE FOLLOWING MATERIALS: 1 - 9/16”...
- Page 4 FIG # 1: IN ORDER TO MAKE THE ASSEMBLY OF THIS MONARQUE BENCH WITH ARMS EASIER WHILE GOING THROUGH THE ASSEMBLY PROCESS THE BOARD POSITIONS ARE NUMBERED AND WILL BE REFERENCED IN LATER STEPS. NOTE: STAND BENCH ENDS FLAT ON GROUND. VIEW IS ONLY TO SHOW DETAIL. #12 X 2”...
- Page 5 #12 X 2” PAN HEAD PHILLIPS SCREW STEP #2: STAND THE OTHER ( 3 ) THREE BENCH ENDS UPRIGHT, ONE AT A TIME, AND PLACE THE BENCH BOARD ALREADY ATTACHED TO THE FIRST BENCH END, ON POSITION 1 BEING SURE TO ALIGN THE PILOT HOLES WITH THE PRE-DRILLED HOLES IN THE BENCH END.
- Page 6 STEP #3: ALIGN THE PILOT HOLES ON THE BENCH BOARD TO THE PRE-DRILLED HOLES ON THE LEFT SIDE OF THE BENCH ENDS. AFTER THE HOLES ARE PROPERLY ALIGNED, FASTEN WITH ( 1 ) ONE #12 X 2” PAN HEAD PHILLIPS SCREW PER BENCH END. NOTE: BE SURE TO TIGHTEN SCREWS COMPLETELY AFTER THIS STEP.
- Page 7 #12 X 2” PAN HEAD PHILLIPS SCREW STEP #5: REPEAT STEPS 1 - 3 TO ATTACH BENCH BOARDS WITH ARM HOLES ( B ) ON POSITIONS 2 & 5. USE ( 1 ) ONE #12 X 2” PAN HEAD PHILLIPS SCREW PER HOLE TO FASTEN. www.belson.com...
- Page 8 #12 X 2” PAN HEAD PHILLIPS SCREW STEP #6: REPEAT STEPS 1 - 3 TO ATTACH BENCH BOARDS WITH ARM HOLES ( B ) ON POSITIONS 3, 4 & 6. USE ( 1 ) ONE #12 X 2” PAN HEAD PHILLIPS SCREW PER HOLE TO FASTEN. www.belson.com...
- Page 9 3/8” FLAT WASHER 3/8” X 2 1/2” HEX HEAD LAG BOLT STEP #7: PLACE THE ARMS ON THE BENCH BOARDS FASTENED TO POSITIONS 3, 4 & 6. ALIGN THE PRE-DRILLED HOLES ON THE BENCH BOARDS WITH THE PILOT HOLES IN THE ARMS. AFTER THE HOLES ARE PROPERLY ALIGNED, FASTEN WITH ( 3 ) THREE 3/8”...