Page 1
111 North River Road North Aurora, IL 60542 Phone: (800) 323-5664 Fax: (630) 897-0573 sales@belson.com Model # PTSTHA Instructions Sheet Recycled Plastic Step Through Picnic Tables 59" 9.5" 29" 5.5" 96" 11" 9.5" 30-11/16" 72" 31" 28" www.belson.com...
Page 2
A - (1) Table Top E - (1) Center Support I - (2) Leg Cross Block B - (2) Seat Plank F - (2) Right Leg J - (2) Fastener Pack C - (2) Under Seat Support G - (2) Left Leg D - (2) Angle Support H - (2) Seat Support K - (2) 3/8”...
Page 3
Leg Cross Block 3/8” Flat Washer 3/8” x 3” Hex Head Lag Bolt Step #1: While the legs are placed in the proper configuration place a Leg Cross Block between the one Left Leg and one Right Leg. Align the holes, Insert (1) one 3/8” x 3” Hex Head with (1) one 3/8” Flat Washer per hole. Note: Do not tighten bolts completely.
Page 4
3/8” x 3” Hex Head Lag Bolt 3/8” Flat Washer Note: Part of the leg has been removed for reference. Please do not remove leg. 3/8” x 3” Hex Head Lag Bolt 3/8” Flat Washer Step #3: While the table top is upside down, fasten the Cross Supports to the Legs. Use (1) one 3/8” x 5” Hex Head Bolt with (1) one 3/8”...
Page 5
3/8” x 5” Hex Head Lag Bolt Align the holes in the ends of the underseat support board with the leg holes. 3/8” Flat Washer Step #5: While the table is upside down, fasten the under seat supports to the Seat Cross Supports. Use (1) one 3/8” x 5” Hex Head Lag Bolt and (1) one 3/8”...
Page 6
#12 x 3” Flat Head Phillips Screw Step #7: With the table in the upright position, fasten the seats to the Seat Cross Supports and Under Seat Supports being sure to center all holes over boards. Use (1) one #12 x 3” Flat Head Screw per hole to secure. www.belson.com...