Related Manuals for Belson Outdoors Picnic Table RP6S
Summary of Contents for Belson Outdoors Picnic Table RP6S
- Page 1 111 North River Road North Aurora, IL 60542 Phone: (800) 323-5664 Fax: (630) 897-0573 sales@belson.com Model # RPS6 Instructions Sheet Recycled Plastic Step Over Picnic Table www.belson.com...
- Page 2 Before assembly, please check to make sure all components are included. C - Table Top (1) - One Table Top D - Seat (2) - Two Seats D - Seat H - Seat Cross Support (2) - Two Seat Cross Supports H - Seat Cross Support G - Under Seat Support (2) - Two Under Seat Supports...
-
Page 3: Tools Required For Assembly
Before assembly, please check to make sure all fasteners are included. (2) - 3/8” x 4” Hex Head Tap Bolt (16) - 3/8” x 5” Hex Head Tap Bolt (8) - 3/8” x 3” Hex Head Lag Bolt (4) - 3/8” x 2-1/2” Hex Head Lag Bolt (46) - 3/8”... - Page 4 Step #1: Whllle the table top is upside-down, fasten the legs to the under top supports being sure that the counter bores are pointing toward the center of the table as shown above. Use ( 1 ) One 3/8" x 5" Hex Head Bolt along with ( 1 ) One 3/8"...
- Page 5 Step #2: Whllle the table top is upside-down, fasten the seat cross supports to the legs. Use ( 1 ) One 3/8" x 5" Hex Head Bolt along with ( 1 ) One 3/8" Flat Washer and ( 1 ) 3/8" Nylon Look Nut per hole to Secure.
- Page 6 Step #3: Whllle the table top is upside-down, fasten the angle supports to the seat cross supports and the center top support. Use ( 1 ) One 3/8" x 2-1/2" Hex Head Lag Bolt and ( 1 ) One 3/8" Flat Washer per hole to secure.
- Page 7 Step #4: Place ( 1 ) One 5/8” x 1” Cross Dowel in each hole of the Center Support as shown in the diagram below. You may need to tap the Cross Dowels in to plae. be sure the score on the dowel head is in line with the length of the Center Support as shown below.
- Page 8 Step #6: While the table top is upside-down, fasten the under seat supports to the seat cross supports. Use ( 1 ) One 3/8” x 3” Hex Head Lag Bolt and ( 1 ) One 3/8” Flat Washer per hole to secure. www.belson.com...
- Page 9 Step #7: Flip the table upright onto the legs. Please take caution while flipping the table. At this point in assembly the table weighs approximately 260 Pounds. www.belson.com...
- Page 10 Step #8: While the table is upright fasten the seats to the seat cross supports and under seat supports being sure to center all the holes over boards. Use ( 1 ) One #12 x 3” Flat Head Phillips Screw per hole to secure. www.belson.com...