Summary of Contents for Belson Outdoors PARK MASTER PMB-WF
Page 1
PARK MASTER Thank you for buying a BELSON OUTDOORS quality product. Please read and follow assembly instructions. Refer to appropriate page depending on the table you wish to put together. If the lumber is not provided by Belson, follow drilling instructions on page (2).
Page 2
BELSON PRE CUT & PRE DRILLED LUMBER KIT (OPTIONAL) LUMBER KIT CONTENTS: CENTER (1) NO MITERED CORNERS, 5 HOLES SIDE (2) 2 MITERED CORNERS, 5 HOLES 4 MITERED CORNERS, 4 HOLES SEAT (2) HOLE FOR PLASTIC MODELS ONLY) NATURAL CEDAR WEATHER GRAY REDWOOD...
Page 3
6’ & ADA WOOD PARK MASTER ASSEMBLY INSTRUCTIONS TOOLS REQUIRED: 9/16” wrench and hammer. 1.- Insert carriage bolts through 3 Top Boards best face and lay (Side with 2 miters facing out - Center no miters - Side with 2 miters facing out ) on a non-abrasive flat surface that will not damage the lumber with the best side facing down.
Page 4
8’ WOOD PARK MASTER ASSEMBLY INSTRUCTIONS TOOLS REQUIRED: 9/16” wrench and hammer. 1.- Insert carriage bolts through 3 Top Boards best face and lay (Side with 2 miters facing out - Center no miters - Side with 2 miters facing out ) on a non-abrasive flat surface that will not damage the lumber with the best side facing down.
Page 5
RECYCLED PLASTIC PARK MASTER ASSEMBLY INSTRUCTIONS TOOLS REQUIRED: 9/16” wrench, hammer, powered screw driver or drill with Phillips tip No. 2. 1.- Insert 2-1/4” carriage bolts through 3 Top Boards best face. Use 2-3/4” carriage bolt for Center Board’s center hole (carriage bolts can be found in the Super Structure hardware package).
Page 6
RECYCLED PLASTIC PARK MASTER ASSEMBLY INSTRUCTIONS (CONTINUED) 10.- Attach Brace to angle on Leg Note: Do not fully tighten using 1” bolts/nuts. Hand fasten nut. any of the nuts from steps 10-11 until step 16 below. 11.- Attach loose end of Brace to Center Bracket center hole using 1”...