During Operation; Electric Start; Forward Travel; Shutting Off The Engine - Hayter Harrier 56 Autodrive VS ES B & S Operator's Manual

DURING OPERATION

Electric Start

Firmly hold the engine stop lever against the handle (1)
and push the electric start button (2) until you hear the
engine start and then release the button. If the engine
stop lever is released, the engine will stop.
(Refer fi g.13)
NOTE: To prolong the life of the starter, do not crank
the engine for more than 15 seconds in any one
minute.
If the engine does not start after repeated attempts,
contact your local Hayter Authorised Service Dealer
or go to briggsandstratton.com.
To prevent engine damage do not operate the electric
start button when the engine is running.

Forward Travel

Firmly hold the engine stop lever (1) against the handle
(2) and push the electric start button (3). Progressively
engage the Sens-a-Speed® lever (4) to power the
mower forward.
(Refer fi g.14)
Ground speed can be accelerated with increased
engagement of the Sens-a-Speed® lever. Fully release
the Sens-a-Speed® lever to stop the mower.
(Refer fi g.14)
Fig. 13 Fig. 14
1
3
2
When the Sens-a-Speed® lever is disengaged, the
mower may be pushed. This feature is useful when
mowing in confi ned areas.

Shutting off the Engine

To shut off the engine, release the engine stop lever
(1) and Sens-a-Speed® (2). Remove the electric start
button (3).
(Refer fi g.15)
Important: When you release the engine stop lever,
the engine should shut off and the blade should stop
within 3 seconds. If they do not, stop using your
mower immediately and contact a Hayter Authorised
Service Dealer.
Emergency stop: As above. If the engine fails to stop,
disconnect the spark plug lead (1) and remove the
electric start button (2).
(Refer fi g.16)

Parking

Park on level ground.
Fig. 15
2
1
4
Fig. 16
1
3
2
16

Turning

To prevent accidents do not raise the front of the
mower excessively when making a turn. Never raise
the rear of the mower when the engine is running.
To make a wide turn, steer the mower with the handle
in the direction required.
To make a tight turn release the Sens-a-Speed® lever,
apply downward pressure on the handle to raise the
front wheels just above ground level and steer in the
required direction.

Trim Side Cutting

Incorporation of a Trim Side allows you to cut right
to the edge. This is ideal for mowing around borders,
raised fl ower beds and retaining walls.
(Refer fi g.17)
Fig. 17
1 2