Related Manuals for Hayter Harrier 48 Autodrive VS BBC
Summary of Contents for Hayter Harrier 48 Autodrive VS BBC
- Page 1 Harrier 48 Autodrive VS BBC CODE475A OPERATOR MANUAL Original Version (EN) From Serial Number: 404000000 and Up Issued: 28/01/2019 Part number: 3428-779 Rev B...
-
Page 3: Table Of Contents
CONTENTS Introduction Before Operation continued Non Grassed Areas Safety 6 - 9 Controls General Safety Before Mowing Safety Alert Symbol During Operation 15 - 17 Before Operation Safety 6 - 7 Starting - General Safety Forward Travel - Fuel Safety Shutting off the Engine During Operation Safety Parking... - Page 4 CONTENTS Maintenance continued Securing Nuts & Bolts Rear Defl ector Carburetor Adjustments Blade Brake Test Lubrication Storage Storage Safety Preparing the Mower for Storage Storage Removing the Mower from Storage Trouble Shooting Warranty EU Privacy Statement Notes 27 - 28...
-
Page 5: Introduction
This mower is designed solely for use in a domestic grass cutting environment. Use in any other way is considered as contrary to the intended use. Hayter Limited reserves the right to amend product specifi cations without prior notifi cation. -
Page 6: Safety
SAFETY General Safety personal injury or death. Before Operation Safety - Fuel Safety This mower has been designed in accordance with EN You can fi nd additional safety information where Fuel is extremely fl ammable and highly explosive. A ISO 5395-2:2017. needed throughout this manual. -
Page 7: During Operation Safety
3 seconds. If it doesn’t, stop using your mower immediately and contact a • Operate the engine only in well-ventilated areas. Hayter Authorised Service Dealer. Exhaust fumes contain carbon monoxide, which is lethal if inhaled. • Keep bystanders out of the operating area. Keep small children out of the operating area and under •... -
Page 8: After Operation Safety
Fuel is fl ammable and explosive, and can cause personal injury. Run the engine dry or remove the fuel with a hand pump; never siphon the fuel. • To ensure optimum performance and continued safety certifi cation of the mower, use only genuine Hayter replacement parts and accessories. -
Page 9: Safety & Instructional Decals
Please ensure all Safety Decals are secured on the mower before using the product. If any of the decals are missing or not secure, do not use the mower, contact your local Authorised Hayter Service Dealer for replacements. WARNING: Improper maintenance, use of non-conforming spare parts, or the removal or modifi cation of the safety decals may cause death or serious injury. -
Page 10: Product Overview
PRODUCT OVERVIEW PRODUCT SPECIFICATION Code 475A Model Harrier 48 Autodrive VS BBC Weight (Net) 48.4 kg Length 1562 mm Width 532 mm Height 1039 mm Width of Cut 480 mm Height of Cut 13 - 60 mm Engine Manufacturer Briggs & Stratton®... -
Page 11: Setup
The engine must be fi lled with handle. the correct grade of oil and fuel before starting the Delivery Checklist • If a cable is damaged, contact a Hayter Authorised engine. Service Dealer. Check that the following items have been supplied correctly. -
Page 12: Engine Detail
SETUP Engine Detail 5. Remove the dipstick and check the oil level. Check that the oil level is at the top of the full indicator (2) NOTE: Disconnect the spark plug lead before on the dipstick. performing any maintenance procedures. •... -
Page 13: Before Operation
fi ll above the bottom of the fuel (Refer fi g.7) Fuel stabiliser and engine oil are both available to tank neck. purchase from your Authorised Hayter Service Dealer. 111-9367 - Lawnmower Oil SAE 30 Hayter 3. Reinstall the fuel cap. 111-9368 - Premium Fuel Treatment Hayter (Refer fi... -
Page 14: Adjusting The Cutting Height
BEFORE OPERATION Adjusting the Cutting Height Controls WARNING: The blade is sharp; contacting the blade WARNING: Improper maintenance, use of non- can result in serious personal injury. Shut off the conforming replacement components, or the removal engine and wait for all moving parts to stop before or modifi... -
Page 15: During Operation
If the engine does not start after repeated attempts, mowing in confi ned areas. the front wheels just above ground level and steer in contact your local Hayter Authorised Service Dealer the required direction. or go to briggsandstratton.com. Shutting off the Engine... -
Page 16: Engaging The Blade
Hayter Authorised Service Dealer. bag fi tted. Refer to Adjusting the Cutting Height. Reduce the height of cut and mow the area again as Trim Side Cutting necessary until the required fi... -
Page 17: Grass Bag
ALWAYS replace a damaged blade. Consult your and engine overloading. Authorised Hayter Service Dealer. Good grass collection depends on good air fl ow through the grass bag. To empty the grass bag, pour out the grass clippings and shake the grass bag vigorously to clean the airways. -
Page 18: After Operation
WARNING: Improper maintenance, use of non (Refer fi g.24) conforming replacement components, or the removal If a cable is damaged, contact a Hayter Authorised or modifi cation of the deck may cause death or Service Dealer. 6. Turn the water on. -
Page 19: Maintenance Schedule
MAINTENANCE SCHEDULE Note: Determine the left and right sides of the mower from the normal operating position. Recommended Maintenance Schedule Maintenance Service Interval Maintenance Procedure Before each use or daily Check the engine-oil level. Clean grass clippings and dirt from under the mower. Check the condition of guards and safety devices. -
Page 20: Maintenance
MAINTENANCE Preparing for Maintenance solvents will dissolve the fi lter. IMPORTANT: Before tipping the mower to change 1. Press down on the latch tabs, on top of the air fi lter the oil or replace the blade, allow the fuel tank to run cover (1). -
Page 21: Changing The Engine Oil
MAINTENANCE Changing the Engine Oil 9. Wipe the dipstick clean with a clean cloth. Servicing the Spark Plug 10. Insert the dipstick into the oil-fi ll tube, but do not NOTE: Run the engine a few minutes to warm the oil Improper maintenance, use of nonconforming screw it in, then remove the dipstick. -
Page 22: Remove & Replace The Blade
If you are uncomfortable (Refer fi g. 30) performing this procedure or do not have a torque wrench, contact a Hayter Authorised Service Dealer. Blade Sharpening WARNING: The blade is sharp; contacting the blade A slightly worn blade may be re-sharpened. Both blade can result in serious personal injury. -
Page 23: Clutch Cable Adjustment
60 mm from the handle. you release the BBC control lever, contact a Hayter or modifi cation of the rear defl ector may cause death Authorised Service Dealer. -
Page 24: Storage
STORAGE Storage Safety • Remove the spark plug, add 30 ml (1 fl oz) of Removing the Mower from Storage engine oil through the spark-plug hole, and pull the Always shut off the mower, wait for all moving parts engine start cord slowly several times to distribute •... -
Page 25: Trouble Shooting
TROUBLE SHOOTING PROBLEM CAUSES CORRECTIVE ACTION PROBLEM CAUSES CORRECTIVE ACTION Engine stop lever released Operate engine stop lever Undulating ground conditions Change direction of travel Engine will not Incorrect oil level Check oil level Blade worn Sharpen blade turn over Uneven cut Obstruction under deck Remove obstruction... -
Page 26: Warranty
Hayter Limited warrants to the original purchaser that this unit shall be free from defects in material and workmanship, under normal, residential use, for a period of fi ve years from the date of purchase or, if used commercially, for a period of 90 days from the date of purchase. To qualify for the 5 year warranty, you must have the mower serviced annually by an Authorised Hayter Service Dealer* within 12, 24, 36 and 48 months of the date of purchase. -
Page 27: Eu Privacy Statement
To do so, please contact us by email at legal@toro.com. If you have concerns about the way in which Hayter Ltd has handled your information, we encourage you to raise this directly with us. Please note that European residents have the right to complain to your... - Page 28 Hayter Limited Spellbrook, Bishop’s Stortford, Herts CM23 4BU England Customer Care Helpline: 0800 616 298 www.hayter.co.uk...