Heat Sink - HP OMEN 15-en0000 Maintenance And Service Manual

3. Remove the solid-state drives
4. Remove the battery (see
5. Remove the left speaker (see
Remove the card reader/audio board:
1. Disconnect the cable from the ZIF connector on the board (1).
2. Remove the Phillips M2.0 × 5.0 screw (2) that secures the board to the computer.
3. Lift the inside of the board upward (3), and then remove the board from the computer (4).
Reverse this procedure to install the card reader/audio board.

Heat sink

To remove the heat sink, use these procedures and illustrations.
Table 6-5 Heat sink descriptions and part numbers
Description
Heat sink for use in models with GeForce GTX 1660Ti and RTX graphics cards
Heat sink for use in models with GeForce GTX 1650Ti graphics cards
Heat sink thermal pad kit for use in models with GeForce GTX 1660Ti and RTX graphics cards
Heat sink thermal pad kit for use in models with GeForce GTX 1650Ti graphics cards
Before removing the heat sink, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
(Solid-state drive on page
Battery on page 37).
Speakers on page 39).
(Preparation for disassembly on page
(Bottom cover on page
32).
31).
Component replacement procedures
Spare part number
L99860-001
L99861-001
M00752-001
L99862-001
31).
41