Speakers - HP OMEN 15-en0000 Maintenance And Service Manual

1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the solid-state drive to the left of the battery
4. Remove the battery (see
Remove the power connector cable:
1. Diconnect the cable from the system board (1), and then remove the cable from the routing along the
fan (2).
2. Remove the Phillips M2.0 × 5.0 screw (3) that secures the power connector cable to the computer.
3. Remove the bracket from the power connector (4), and then remove the power connector cable from the
computer (5).
Reverse this procedure to install the power connector cable.

Speakers

To remove the speakers, use this procedure and illustration.
Table 6-3 Speaker description and part number
Description
Speaker Kit
Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
(Preparation for disassembly on page
(Bottom cover on page
Battery on page 37).
(Preparation for disassembly on page
(Bottom cover on page
31).
(Solid-state drive on page
31).
Component replacement procedures
31).
32).
Spare part number
L98748-001
31).
39