Quick BTR185 Series Installation And Use Manual page 33

4 - Installation
Fig. 12
HULL
15 mm
Fig. 13
4.3 - Thruster's installation
Fig. 14
ACTUATOR
Part. 14B
Part. 14A
O-RING
• Remove the adhesive backings, previously applied, from the counter flange.
• Make sure the area where the gasket will be positioned is clean and has not suffered
any damage during installation.
• Position the o-ring on the counter flange (part. 14A), assemble the thruster (fig.14),
spread marine grease on the thread of the bolts (fig.14B) and fasten securely with sup-
plied screws.
The bolts and screws of the counter flange must be tightened to 25Nm, tightening
F
little by little in a crossed sequence, following a scheme such as in the example in
figure 14C.
WARNING: about one week after installation, you should check that all screws are
properly tightened in order to compensate for any potential o-ring settling.
COUNTER FLANGE
LID
N 2 SCREWS M8
• Drill the angle bar and fasten securely with the other two M8 screws
ACTUATOR
HANDLE
THRUSTER
BTR185 INSTALLATION AND USE MANUAL - REV009A
Min. 5 mm
HINGE
WARNING: in order to allow a stable fixing of hinge and bracket,
the lid must present neither empty areas nor non-structural fillings
inside (fig. 12).
(fig. 13).
HULL
BTR185
ANGLE BAR
Min. 80 mm
MOTOR
NUT
WASHER
O-RING
Fig. 14C
COUNTER FLANGE
WASHER
BOLT
7
2
10
4
8
EN
HULL
11 5
3
9
1
12 6
33