Table of Contents
Advertisement
Installing the Device
2.2 Unpacking the Device
ment ratings. Make sure to review all operating and installation instructions before
commissioning or performing maintenance on the device.
1.
2.
3.
4.
5.
6.
7.
2.2
Unpacking the Device
When unpacking the device, do the following:
1.
2.
3.
NOTICE
If any item is missing or damaged, contact Siemens for assistance.
2.3
Mounting the Device
The RUGGEDCOM RS401 is designed for maximum mounting and display flexibility. It
can be equipped with connectors that allow it to be installed in a 35 mm (1.4 in) DIN
rail or directly on a panel.
IMPORTANT
Heat generated by the device is channeled outwards from the enclosure. As such, it
is recommended that 2.5 cm (1 in) of space be maintained on all open sides of the
device to allow for some convectional airflow.
8
Review the relevant certification information for any regulatory require-
ments.
For more information, refer to
Unpack and inspect the device.
For more information, refer to
Mount the device.
For more information, refer to
Connect the failsafe alarm relay.
For more information, refer to
14)".
Connect power to the device and ground the device to safety Earth.
For more information, refer to
Connect the device to the network.
For more information, refer to
Configure the device.
For more information, refer to
Inspect the package for damage before opening it.
Visually inspect each item in the package for any physical damage.
Verify all items are included.
"Approvals (Page
35)".
"Unpacking the Device (Page
"Mounting the Device (Page
"Connecting the Failsafe Alarm Relay (Page
"Connecting Power (Page
"Communication Ports (Page
"Configuring the Device (Page
Installation Manual, 01/2020, C79000-G8976-1017-09
8)".
8)".
16)".
21)".
20)".
RUGGEDCOM RS401
Advertisement
Table of Contents
