Checking Video In Format; Checking Main And Control Firmware Version - Datavideo SE-1000 Instruction Manual

Checking Video In Format

Each converter automatically selects the Video Input Format according to the signal that it receives. You can
check the format on the LCD panel.
With the LCD displaying the status for channel 1, press the Adjustment Knob to bring up the Format
Standard Converter Adjustment Menu, and rotate the Adjustment Knob until FN08 is displayed.
Press the Adjustment Knob and the display will show the video input format
Press the Adjustment Knob again and the display will return to the previous screen
To Exit the set up menu rotate the Adjustment Knob clockwise until FN13 - EXIT is displayed and then press
the Adjustment Knob.
Note: If no adjustments are made within 20 seconds the LCD will return to the status display
automatically.
Checking Main and Control Firmware Versions
Occasionally you may be required to supply the firmware version numbers to an engineer, this is where you
can find them.
With the LCD displaying the status for channel 1, press the Adjustment Knob to bring up the Format
Standard Converter Adjustment Menu, and rotate the Adjustment Knob until FN09 - Main Firmware or FN10
Control Firmware is displayed.
Press the Adjustment Knob and the display will show the firmware revision number
Press the Adjustment Knob again and the display will return to the previous screen
To Exit the set up menu rotate the Adjustment Knob clockwise until FN13 - EXIT is displayed and then press
the Adjustment Knob.
42
.
.
.
.